2003 Honda GL1800 Recalls
Learn What to Do if Your GL1800 Has Been Recalled
The following recalls have been announced by Honda, so if you own a 2003 GL1800 take action immediately to get your automobile fixed. Interested in how this information is collected? Read more about recalls and the NHTSA.
- Call Honda to get more information. Verify that the cost of repairs will be covered free of charge
- Setup an appointment with a local authorized mechanic to schedule your maintenance
- Keep up to date with recalls for your vehicle by following this page
Recent 2003 GL1800 Recalls
-
STRUCTURE:FRAME AND MEMBERS Recall for 2003 HONDA GL1800
Summary: On some motorcycles, certain frame welds do not meet manufacturing specifications. High loads created when riding on rough road surfaces or through potholes can cause the affected welds to crack.
Consequence: The welded area could break, resulting in rear suspension collapse or lower cross member separation, increasing the risk of a crash.
Fix: Dealers will inspect and, if necessary, reinforce the welds on 2001-2002 motorcycles free of charge. On 2003-2004 motorcycles, the units will be repaired, no inspection will be necessary. The recall began on February 9, 2005. Owners may contact Honda at 1-866-784-1870.
For detailed information & supporting documents, see the official NHTSA page concerning recall #05V027000 »
-
SERVICE BRAKES, HYDRAULIC Recall for 2003 HONDA GL1800
Summary: Certain motorcycles equipped with combined-brake systems have a proportioning control valve (PCV) that mechanically proportions brake force when the rear brake is applied. A seal in some pcvs is improperly shaped, and brake fluid leakage may occur.
Consequence: If the motorcycle continues to be used after a leak occurs, the rear brake would eventually become inoperative. A loss of rear brake force could increase the risk of a crash.
Fix: Dealers will inspect the rear brake forleakage. If leakage is confirmed, the dealer will replace the PCV free of charge. The recall began on January 31, 2005. Owners may contact Honda at 866-784-1870.
For detailed information & supporting documents, see the official NHTSA page concerning recall #05V010000 »
-
STRUCTURE: FRAME AND MEMBERS:UNDERBODY SHIELDS Recall for 2003 HONDA GL1800
Summary: On some motorcycles, certain frame welds do not meet manufacturing specifications. High loads created when riding on rough road surfaces or through potholes can cause the affected welds to crack.
Consequence: The welded area could break, resulting in rear suspension collapse or lower cross member separation, increasing the risk of a crash.
Fix: Dealers will inspect and reinforce the welds on all frames. Owner notification began during October 2003. Owners should contact Honda at 1-866-784-1870.
For detailed information & supporting documents, see the official NHTSA page concerning recall #03V350000 »
-
FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP Recall for 2003 HONDA GL1800
Summary: On certain motorcycles, the bank angle sensors designed to shut off the fuel pump and the engine electrical power in the event the motorcycle falls over, were installed using the wrong size screws allowing the screws to eventually detach from their mounting point.
Consequence: If the sensor detaches, the engine will stop unexpectedly. Sudden loss of engine power, especially while turning, could cause a crash.
Fix: Dealers will inspect the mounting screw size and, if necessary, install screws of the correct size. Owner notification began December 23, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Honda at 1-800-289-8226.
For detailed information & supporting documents, see the official NHTSA page concerning recall #02V340000 »